Die Suche ergab 127 Treffer
- Freitag 2. November 2012, 11:42
- Forum: Accommodation
- Thema: Double Berth in Saloon
- Antworten: 1
- Zugriffe: 51547
Re: Double Berth in Saloon
Pictures from the original post.
- Mittwoch 31. Oktober 2012, 22:47
- Forum: Hull & Deck
- Thema: Mast Step (Re-Post from Temptress)
- Antworten: 0
- Zugriffe: 58441
Mast Step (Re-Post from Temptress)
These are photos that were posted in the wonderful and sadly missed Ballad Exchange. They show a mast step renewal on Temptress (I think).
by Nicholas
by Nicholas
- Samstag 9. Juli 2011, 15:15
- Forum: Hull & Deck
- Thema: Teak cockpit parts from Martinssons Batsnickeri, SE
- Antworten: 3
- Zugriffe: 23038
Re: Teak cockpit parts from Martinssons Batsnickeri, SE
msn-s채lta wrote on Aug 5, '07 Hi! I have had the same problem as you describe. The plywood delaminated due to bad fitting of the rubberlist. My solution was that i removed all teakribbs and bought a new better plywood and then put all things back again. However I must say that I can't reckommend th...
- Samstag 9. Juli 2011, 15:04
- Forum: Hull & Deck
- Thema: Teak cockpit parts from Martinssons Batsnickeri, SE
- Antworten: 3
- Zugriffe: 23038
Re: Teak cockpit parts from Martinssons Batsnickeri, SE
We bought the locker lids from http://www.lidkopingsbatsnickeri.se/ in the beginning of 2007, and after finding out (as described elsewhere) that the aft lid was not rectangular because the locker is not, it was easy enough to fit the lids, and they looked good. However, the lids are now comming apa...
- Samstag 9. Juli 2011, 15:03
- Forum: Hull & Deck
- Thema: Hull anodes
- Antworten: 1
- Zugriffe: 16784
Re: Hull anodes
msn-aballport wrote on Sep 10, '07 Nicholas, On most boats the shaft zinc is electricaly connected to the engine block. In some cases a flexible coupling may break this connection but a jumper strap can restore it. Sometimes when my boat is not being used frequently I will put a zinc guppy on it. T...
- Samstag 9. Juli 2011, 15:03
- Forum: Hull & Deck
- Thema: Hull anodes
- Antworten: 1
- Zugriffe: 16784
Hull anodes
Hi to all: Does anyone out there have a hull anode on his/her boat? (It's usually the turtle-shaped zinc anode where you attach the bonding cable.) Most people attach the negative battery terminal to their engine block, but I understand it's better to then take another cable from that point to a hul...
- Samstag 9. Juli 2011, 15:02
- Forum: Hull & Deck
- Thema: Cleats
- Antworten: 0
- Zugriffe: 16915
Cleats
Hi to all: I was tired of varnishing or oiling the teak wooden pieces that are part of the forward and aft cleats--I had even tried epoxy-coating them, without lasting results--so I thought that it'd be a lot more convenient to replace them with stainless steel pipes. Luckily, 40mm and 30mm stainles...
- Samstag 9. Juli 2011, 15:01
- Forum: Hull & Deck
- Thema: Window seals
- Antworten: 1
- Zugriffe: 17118
Re: Window seals
msn-patentnick1 wrote on Oct 18, '07 There may be another, less drastic solution to your problem which I implemented when I had a slightly leaking window. This process doesn't involve removing the windows. First, I excised all the rubber gaskets with a utility knife and a curved blade, both on the ...
- Samstag 9. Juli 2011, 15:01
- Forum: Hull & Deck
- Thema: Window seals
- Antworten: 1
- Zugriffe: 17118
Window seals
I wrote the message last night but forgot to attach the photo so I will start again. My ballad has a leaking window and the seal needs replacing. I have tried to obtain a matching one in the UK but so far without success. Attached is a photograph of the seal section end on. It is 15mm from the base ...
- Samstag 9. Juli 2011, 15:00
- Forum: Hull & Deck
- Thema: Midships fairleads
- Antworten: 1
- Zugriffe: 17064
Re: Midships fairleads
msn-puredrop5 wrote on Jan 30, '08 You can get cleats on a slider like the jib sheet cars have, fit them on the forward end of the jib sheet track. Mark bennett CIAO msn-ballad775 wrote on Jan 30, '08 I've got them on a track on the rail, like this; which runs from about midships right back to the ...
- Samstag 9. Juli 2011, 14:59
- Forum: Hull & Deck
- Thema: Midships fairleads
- Antworten: 1
- Zugriffe: 17064
Midships fairleads
Hi to all: If you've ever needed to use a midships spring but had no place to either tie a rope or pass a line through, then a pair of midships cleats or fairleads in the area just forward of the spinnaker track are the answer. I chose fairleads since you can pass a rope through and control it from ...
- Samstag 9. Juli 2011, 14:57
- Forum: Hull & Deck
- Thema: Keel construction
- Antworten: 1
- Zugriffe: 19029
Re: Keel construction
jespermilling wrote on Apr 8, '08 The keel won't fall off. I think the construction is very strong. We hit a rock, and a big chunk of fiberglass was chipped off. A few months later it was repaired at a highly respected boatyard (Walsted in Denmark) and they remarked that the GRP was very dry, in sp...
- Samstag 9. Juli 2011, 14:55
- Forum: Hull & Deck
- Thema: Keel construction
- Antworten: 1
- Zugriffe: 19029
Keel construction
Hi all! I have had my Ballad for almost 2 years now, and I just love the boat more and more. When we were to buy it, we compared Ballad, Comfort 30 and Scampi, and looked at several boats of all 3 types. The Ballad was absolutely the best. However, one thing that is commonly regarded as a "weak...
- Samstag 9. Juli 2011, 14:53
- Forum: Hull & Deck
- Thema: Stanchion
- Antworten: 1
- Zugriffe: 19108
Re: Stanchion
msn-redmed6 wrote on May 13, '08 I'm assuming stainless: any hope the bent stanchion length can be "rolled" back into shape by a motor cycle repair shop (or a section bender)? Stanchion base maybe more of a challenge: I can't suggest a supplier. msn-patentnick1 wrote on May 13, '08 Hi Tim...
- Samstag 9. Juli 2011, 14:51
- Forum: Hull & Deck
- Thema: Stanchion
- Antworten: 1
- Zugriffe: 19108
Stanchion
Hi, Does anyone know where I can get a new stanchion, and stanchion base, please? Unfortunately one of Gancia Girl's Stanchions has been damaged by a fishing boat which lost control whilst entering Pwllheli harbour. The skipper of the fishing boat failed to notice that the flooding tide was pushing ...